Machining DataSheet for

General Information:
Material GroupP - Steel
Sub-GroupLow Carbon Steel
Tensile Strength460-500 [N/mm^2]
Machinability Range65% - 80%

Watch the Video:
"How to use the Material Pages"
and get the most out of this page!

Watch Video

Equivalent International Designations for Steel A34-2NE

Standard Name
wnr1.0034
dinRSt34-2
bs144934/20HR,HS,CR,CS
anforA34-2NE
uniFe330BFN

Chemical Composition for Steel A34-2NE

Sorry, Not Availble for this Material


Cutting Speeds Recomendations for Non-alloyed steel 0.1-0.25% Carbon

* Click on the speeds below for higher precision in specific conditions!

ApplicationVc (m/min)Vc (SFM)
Turning285-350930-1150
Milling175-220570-720
Parting135-170440-560
Grooving160-195520-640
Drilling115-140380-460

Important! The speed estimation is given for an ideal situation:

  • Most suitable carbide grade
  • Stable tool clamping
  • Stable workpiece clamping
  • Good quality raw material
  • A short overhang of the cutting tool.
  • Nominal hardness of the material.
  • etc.
Click on the speeds in the above table to get better precision for specific parameters
Or use our Speed and Feed Calculator


Recommended Carbide Grades for Steel A34-2NE

* If you do nott understand the below table? Read This Explanation to make the most out of it!

Grade for Turning

Grade for Parting Off

Grade for Grooving

Grade for Milling (Indexable)

Recommended Insert Cutting Edge Geometry for Steel A34-2NE

Honing Size:0.05-0.08 mm / 0.002-0.003"
Rake Angle:11° -13°
Land Angle:Positive
Land Width:0.20-0.30 mm / 0.008-0.012"

Learn more about carbide inserts Cutting-Edge Geometry Parameters.

Start typing and press enter to search

Scroll to Top